Maintenance Points Of Scraper Winch Accessories

If the friction plate of the scraper winch is stained with oil, you can step on the clutch pedal, use the oil gun to load the gasoline, aim at the gap between the flying wheel, the friction plate and the clutch pressure plate, and shoot the oil to dissolve the above oil. If the friction plate slips due to burning, you can roughen the burning part, but you need to start smoothly when driving, and speed change quickly.

The scraper winch leaf spring is broken. According to the situation, the leaf spring, the bridge and the frame are padded with wood blocks, which are bound with iron wire for temporary use and driven to the repair point for replacement.

When the front wheel or single tire is removed and replaced, the front axle or rear axle can be cushioned with wood block or brick or stone. When the front wheel or single tire is removed and replaced, the front axle or rear axle can be cushioned with wood block or brick or stone, and the tire to be removed can be removed and replaced by digging a hole on the tire to be removed, so that the tire can be removed and replaced. A section of flat top wooden ramp is used under the front axle or rear axle where the tire needs to be replaced, Then start the car to jack up the front axle or the rear axle with the top wood. When the top wood is vertical and stable, the tire can be removed and replaced.

The fan belt of scraper winch is damaged, mostly broken. Several strands of thick rope can be used for rubbing. Its length and thickness should be similar to that of the original fan tape, but the rope head should flash in the middle and not be exposed, and then it should be bound with iron wire; a small hole can be drilled at each end of the original fan tape break, and the thick wire can be used for temporary connection.