Steel Bar Bender Safety Operation Rules

1. Checking if the steel bar bender machinery properties is good. Working disk and steel bar bender table keep level, ready well each kind the core shaft tool shift 2. Install the core shaft and other shafts well according to the steel bar bending dia and the requirement of steel bar bender. The dia of core shaft should be 2.5 times of the rebar dia. 3. Checking if any damage, crack for the core shaft, stopper block, rotary plate, if the cover is fixed well and reliable. Make the empty machine run, confirm all is ok, then start to work. 4. Insert one end of rebar in the gap in rotary disk, make the other end close to the steel bar bender body, fix well and squeeze by hand, check if the steel bar bender body fix well. Double check it is surely installed on the side of stopping rebar, then can start. 5. Strictly forbid to change the core shaft, adjust the angle, adjust the speed while the machine works. 6. Strictly forbid to add oil or clean the machine while the machine work. 7. Strictly forbid to process bigger dia rebar than the machine allowing. 8. Strictly forbid to adjust higher speed than the machine allowing. 9. Strictly forbid anyone stand at the side of the steel bar bender no setting fixing. 10. Strictly forbid anyone is at the place of dia of the steel bar bending working. 11. While change the way of the rotary disk, it must be after the machine stop well. 12. While bend the higher hardness rebar or low alloy rebar, it should be in the scope of the machine allowing. At the same time, the core shaft should be also changed. 13. The half-finished products and finished products should stack well, the hook should not be up. 14. The steel bar bender should be stop at once if the motor is too heat, or the working disc flutter in the working process.